Model Saturn A2
The smallest and most economical
Clean Burn used-oil furnace in terms of initial cost.
It produces approximately 140,000 BTU/hr. and is ideal
for small garages, shops, and workspaces.
• Engineered from the ground up to burn used
oils
• Patented heat exchanger generates more heat
• Unique non-welded flue tubes for longer service life
• Advanced burner preheats oil, regulates and optimizes combustion
• New smart control with auto-start for safe, reliable ignition
• Longest cleaning interval of all units in its class
• Lower stack temperatures, higher heat output
• Automatic flow control means no fuel adjustment required
• Ideal for unit heating, or as part of a Clean Burn Recycling Center
• Unequaled service & support from your Clean Burn Distributor
Saturn A2 Specifications
Maximum BTU/hour*
140,000 (41 kW)
Maximum
Oil Consumption*
1.0 GPH (3.8 L/h)
Fuels
Used Oils
Crankcase, ATF, hydraulic
Fuel Oils
#2 and #4 fuel oils
Airflow Output (CFM)
Unit Heater
1600
Air Compressor* (required)
2.0 CFM @ 20 PSI
(3.4 m3/h @ 1.4 bar)
Stack Size
8 inch dia. (203mm dia.)
Furnace Dimensions - assembled
40” L x 46" W x 29 " H
(1016mm x 1168mm x 737mm)
Approximate Weight
325 pounds (147 kg)
Electrical Requirements
115 VAC 60 Hz, single phase
20 Amp circuit breaker
* Values indicated
above are nominal. Actual values will vary depending
on fuel and installation.
Furnace system includes: check valve and filter screen, in-line washable
canister filter, barometric damper, wall thermostat and oil supply pump.
